Shock absorbers manufacturers teach you autos break-in period how to drive

          
Cars become more and more popular, new drivers are joining.But many drivers don't know about cars, there are many driving errors.Break-in period had a great influence on the lifetime of the car and fuel consumption,Because a run-in period of wear could cause part surface injury cause scarring,The scar will increase the friction resistance,This scarring can also accommodate scrap metal, sludge and other debris,These debris will wear in the sport continues to expand, will eventually cause problems, so running quality determines the car's life,China shock absorbers manufacturers summarizes break-in period 6 taboo.

1).Don't emergency brake:Emergency brake would make compromised brake system of the break-in period, will also increase the load on the chassis and engine,Within the first driving 300 km, it is best not to emergency braking.

2).Don't overload:New car in break-in period overload operation, can cause damage to the car parts.Therefore, within the first driving 1000 km, the average load not more than 75% to 80% of the rated load.

3).Don't long distance driving:New car run long distance during the break-in period, the engine of continuous working time will increase, easy to cause auto parts wear and tear.

4).Don't be speeding:When you give full throttle, speed cannot exceed a maximum speed of 80%,and pay attention to in the driving engine tachometer and speed table, make sure not to speeding.Under normal circumstances, the break-in period engine speed 2000-4000 r/min.

5).Don't early to an oil change:New car break-in period with special lubricants, requires low oil viscosity, good heat, clean, excellent oxidation resistance,Some auto manufacturers have joined the abrasives, so the break-in period oil as long as in accordance with the manufacturers time to change,don't early to an oil change.

6).Starting to warm the car:New cars must be preheated before starting, the so-called preheating is actually a sufficient lubrication for engine's time,Especially the turbocharged models, have to warm-up before you can start, and lubricated for at least a minute or more.

Should also pay attention to in the break-in period the speed too slow, easy to cause the vehicle wear and tear.Break-in period is a period of time will be friction parts grinding to a reasonable range, to achieve better lubrication.

Break-in period the engine speed is too low, crankshaft connecting rod bearings to withstand the impact is large,Speed is too high then the cylinder wall easy to strain, resulting in early wear and tear, so period shall refer to engine speed rather than speed,Gasoline engine speed between 2000 ~ 2000 RPM, the diesel engine is between 1000 ~ 1000 RPM.

For more detailed information on auto parts and vehicle maintenance, visit the provider china shock absorbers manufacturers and china clutch manufacturers.